These hazard light instructions were provided by an ISRA member named Pedro. They were copied from a message post (#51114.16) on the ISRA Forum (http://forums.delphiforums.com) and are provided for informational use only.

..... start of copy .....

Over the weekend I installed the parts and now my bike has working hazard lights!

Instructions and parts needed are:

Parts:
- Radio Shack inline blade fuse holder #270-1213 (I'm using a 10A fuse)
- Two pin flasher from Autozone #552
- Radio Shack mini flat lever switch DPDT #275-636B
- 16 gauge wire

Instructions:
1. Splice into the top wire of the "signal fuse" wire (located in the tool/fuse area) and connect one end of the "Fuse holder #270-1213" to it.
2. Connect the other end of the "fuse holder" to the X terminal of the "Flasher #552".
3. Connect a wire from the L terminal of the "flasher" to both terminals on one side of the "Switch #275-636B".
4. Connect a wire from the center left side of "switch" to the "green wire" located under seat that is running to the rear fender.
5. Connect a wire from the center right side of "switch" to the "brown wire" located under seat that is running into the rear fender.
6. Install switch anywhere you want. I installed mine on a bracket then installed the small bracket onto a bolt that is holding the main fuse box. The switch sticks out the left side of the tool/fuse side keyed cover.

I made a diagram, if you want me to e-mail it to you, let me know.

Hope this works for you too.

Pedro
Bronx, NY
2001 V* 1100 Classic

..... end of copy .....

Return to Bike Mods Page